SECTION I: PRODUCT NAME AND COMPANY IDENTIFICATION
PRODUCT NAME: WEATHER MASTER WSR
GENERIC NAME: Fluor-coating Material for Stone & Concrete
MANUFACTURER : THE ALFIERI - McBEE CORPORATION
707 SHEPHERD LANE, SUITE 103
GARLAND, TEXAS 74042
EMERGENCY TELEPHONE NUMBER: (972) 494-4800
SECTION II: COMPOSITION / INFORMATION ON INGREDIENTS
Component Mass % CAS No. OSHA PEL ACGIH TLV
Fluorocompounds 3 - 5 Trade Secret --- -----
Isopropyl Alcohol 15 - 17 67 - 63 - 0 400 PPM 400 PPM
Water 79 - 81 7732 - 18 - 5 ------ -----
SECTION III: HAZARD IDENTIFICATION
Potential Heath Effects:
Eye - Can cause eye irritation. Symptoms include stinging, tearing. redness, and swelling of eyes.
Skin - May cause mild skin irritation. Prolonged or repeated may dry the skin. Symptoms may include redness, burning, drying and cracking of skin, and skin burns. Passage of this material into the body through the skin is possible, but it is unlikely that this would result in harmful effects during safe handling and use.
Swallowing - Swallowing small amounts of this material during normal handling is not likely to cause harmful effects. Swallowing large amounts may be harmful. This material can get into the lungs during swallowing or vomiting. This results in lung inflammation and other lung injury.
Inhalation - Breathing of vapor or mist is possible. Breathing large amounts may be harmful. Symptoms usually occur at air concentrations higher than the the recommended exposure limits ( See Section B).
Chronic Effects - No specific data available.
Warning: Vapors and fumes liberated during hot processing with this material may cause flu-like symptoms ( chills, fever, and sometimes cough) that may not occur until several hours after exposure and typically pass within 36 to 48 hours
Carcinogenicity Information. None of the components present in this material at concentrations equal to or greater than 1% is listed by IARC, NTP, OSHA, or ACGIH as a carcinogen.
SECTION IV : FIRST AID MEASURES
Inhalation - Remove to fresh area. Keep warm and at rest. Give artificial respiration if not breathing. Consult a physician.
Skin Contact - Wash thoroughly with soap and water immediately. Wash contaminated clothing before reuse.
Eye Contact - Flush with plenty of water for 15 minutes (remove contact lenses if easily as possible). Consult a physician
Ingestion - Immediately give two (2) glasses of water. Call a physician.
SECTION V: FIRE-FIGHTING MEASURES
Flash point: 101 degrees F
Extinguishing Media: Foam, dry chemical, carbon dioxide
Fire and Explosion Hazards: Vapors are heavier than air and may travel along the ground or may be moved by ventilation and ignited by pilot lights, other flames, sparks, heaters, smoking, electric motors, static discharge or other ignition sources at distant from material handling point. Never use welding or cutting torch on or near drum ( even empty) because product (even just residue) can ignite explosively.
Warning: Hazardous decomposition products including carbon dioxide, carbon monoxide, hydrogen floride, toxic gases or particles may be informed during combustion. These products may cause severe eye, throat, and lung irritation or toxic effect.
Wear self-contained breathing apparatus (SCBA) and full protective equioment.
SECTION VI: ACCIDENTAL RELEASE MEASURES
General Information: Use proper personal protective equipment as indicated in Section 8.
Spills / Leaks: Absorb spillages onto sand, earth or any suitable absorbent material. Transfer to covered steel drums for recovery or disposal.
SECTION VII: HANDLING AND STORAGE
Handling: Use proper personal protective equipment as indicated in Section 8. Use in well ventilated areas. Exposure to toxic gases through inhalation can occur if smoking tobacco becomes contaminated by this material. Therefore do not smoke in the work areas and wash hands and face after handling in order to avoid transfer of the material onto smoking tabacco.
Keep containers tightly closed
Store in a cool, dry place. (-5 to 40 degrees) C
Keep away from direct heat or sunlight.
SECTION VIII: EXPOSURE CONTROLS / PERSONAL PROTECTION
TLV: 400 ppm (as TWA): 500 ppm (as STEL) (ACIGH 1998).
Engineering Controls: Provide general or local exhaust ventilation systems.
Personal Protective Equipment:
Eyes - Wear safety glasses or coverall chemical splash goggles.
Clothing - Wear impervious gloves (Neoprene or Nitrile), pants and jacket.
Respirators - Wear NIOSH approved respiratory protection, as appropiate.
SECTION IX: PHYSICAL AND CHEMICAL PROPERTIES
Appearance Pale liquid
Odor Alcohol - like
Boiling Point / Range Not Tested
Melting Point Not Tested
Flash Point >101 degrees F
Explosive Properties No Data
Auto Ignition 101 degrees F
Specific Gravity .98 at 25 degrees C
Water Solubility Miscible
Viscosity No Data
SECTION X: STABILITY AND REACTIVITY
Stable at room temperature in closed containers under normal storage and handling conditions.
Conditions to Avoid:
High temperatures by heating and open flames.
None reasonably foreseeable.
Thermal Decomposition Products:
Carbon Dioxide, Carbon Monoxide, Hydrogen Fluoride, toxic gases or particles.
Polymerization will not occur.
Material Safety Data Sheet